Rénov concrete CML®

The Rénov concrete SMCS® is a revolutionary product that allows you to renovate in a way that is extremely easy and fast a old concrete.

With a choice of 9 colors including white that can be colored with our colorants liquids, it is certain that you will find a color for your renovation.

Its method of application using a roller is at the reach of all. Its low consumption allows to have a cost in m2 for less than 3 € TTC.

Finally, it is a product anti-slip in nature. So perfect if around a swimming pool or a terrace, there is need to make the surface non-slippery.

CHARACTERISTICS

Type : Mortar of renovation.

Colors : 10

Packaging : Bucket of 7.5 or 15 kg

Conforming to standard NF EN 13813.

Consumption : 300 to 375 / m2.

Conservation : 12 months in its original packaging unopened and stored in a dry place and away from frost.

PREPARATION & SUPPORT

The support should be resistant, healthy, strong, clean. In the case of remains of paint or varnish, get a mono brush equipped with a green Pad or black in order to eliminate any residual non-adherent.

Use Harmony neutral Cleaning agent for any cleaning necessary (grease, oil, dirt).

STAINING

The colouring is done by the addition of the dye liquid HB Colour of the water according to the ratio of 1 dose to 8 liters of water.

Shake together before use.

IMPLEMENTATION

The application temperature shall be between a minimum of +5 and +25 °c without the risk of rain in 12 hours.

On a concrete printed unglazed and porous, dampen the surface prior to the application of the Rénov concrete SMCS In the case of a very porous surface, it is advisable to apply a layer of Harmony Prim in order to reduce any risk of bubbling.

On a concrete nail, the application can be done directly without primer.

Dosage : Mix at the rate of 1.5 kg of Rénov concrete CML for 750 to 800 ml of water .

Pour the mortar into the water and mix at slow speed to obtain a mortar fluid according to the ration of 1.5 kg of Rénov concrete CML for 750 to 800 ml of water .

After mixing, pass the mixture through a fine sieve to eliminate any risk of lumps.

Apply using a roller of the type of our special sleeve to ground.

Allow to dry 4 hours before applying a 2nd coat if necessary.

In the case of a concrete printed, leave to dry for 24 h at 20°c prior to the implementation of the enhancer of relief. See technical data sheet of the enhancer of relief.